-Anybody have a suggestion on how best to cut steel braided fuel line, leaving
a neat (non frayed) end?
I need to replace the short piece between the 2nd and 3rd carbs, and have a
long piece I could cut. -I know enough to push the rubber caps on to the
middle of the piece to be used, then slide them out to the ends of the line
once cut.
I was thinking of cutting the line using a small thin cut-off disk on my
Dremmel tool at high speed (even if only to cut the steel braid). Any other
thoughts?
Dave J.
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|