healeys
[Top] [All Lists]

Re: Suspension travel - Max Bump & max Droop of the back &

To: thehartnetts@earthlink.net, healeys@autox.team.net
Subject: Re: Suspension travel - Max Bump & max Droop of the back &
From: Jerry Wall <jwbn6@iopener.net>
Date: Sat, 31 Jul 2004 11:50:27 -0500
wouldn't the measurement from ground to top of wheel opening be a function of 
the tire diameter?
Len and/or Marge wrote:
 > 
 > Chris:  Can't give you any info on suspension travel but following is a
 > reprint of a message I sent previously regarding ride height:
 > 
 > From some ancient tech session notes (1978) I extract the following: from
 > the ground to the top of the wheel opening, BJ8s 28 inches, all others 27
 > inches. And from my Drake manual: height over scuttle 3 feet. Although I
 > can't find the reference, I seem to remember that this was the measurement
 > from a point on the center of the front shroud about an inch or two in front
 > of the windshield, to the ground. I just went out to the garage and using a
 > yard stick, line level, and tape measure, find that my BJ8 is pretty close
 > to that.
 > 
 > (The Other) Len
 > Vacaville, CA
 > 1967 3000 MKIII HBJ8L39031
 > 
 > 
 > > [Original Message]
 > > From: Chris Dimmock <cd3000@bigpond.net.au>
 > > To: <healeys@autox.team.net>
 > > Date: 7/31/2004 2:53:41 AM
 > > Subject: Suspension travel - Max Bump & max Droop of the back &
 > frontwheels of a BJ8?
 > >
 > > Does anyone know (or have a std BJ8, in a condition to be able to measure)
 > > the total suspension travel (i.e. from the stationary 'centre point' ) the
 > > max Bump & max Droop of  the back & front wheels of a BJ8? ie I'm trying
 > to
 > > determine total suspension travel & whether the std ride height is 'in the
 > > middle'.
 > >
 > > My car's ride height means it isn't the right car to try to do this
 > > on.............
 > >
 > > :)
 > >
 > > Let me know if you can help.
 > >
 > > Thanks in advance guys.
 > >
 > > Chris
 > > www.myaustinhealey.com
 > 
 > * 





<Prev in Thread] Current Thread [Next in Thread>