Lin,
On all 6 cylinder models the blower assembly is mounted to the inner wheel
well using 4 dull olive green fender style bolts passing through dull olive
green flat washers and anchor into "J" nuts that slip onto the blower
bracket flanges. The brackets to blower case mountings use rubber grommets
similar to the windscreen wiper motor mounts.
Rich Chrysler
----- Original Message -----
From: "linwood rose" <linwoodrose@mac.com>
To: "list healey" <healeys@autox.team.net>
Sent: Thursday, July 15, 2004 6:28 PM
Subject: heater blower mounting
> Hello all,
> For the 60 BT7, I have seen the Smiths heater blower brackets attached
> to the inner fender with washers and "J" nuts. I have also seen the
> brackets mounted through rubber grommets into the inner fender. Which
> is correct? Were grommets added on later cars or did they all have
> them? When I disassembled my car it did not have the rubber grommets.
> Thanks.
> Lin
> 1960 BT7 in restoration
> 1959 Bugeye
|