loosen the blower motor until the screws are just barely hanging in the clip
retainers, start both hoses on the blower ( dont forget to have the large hose
clamps on the hose ) and then pull the blower motor back into place with the
screws. a large amount of patience is required along with a little smear of
hand cleaner around the mounting area of the blower.
davidwjones wrote:
>
> GlacierFoolishly, in the restoration of my car ('62 BT7 tricarb) the
> corrugated air hoses to the heater fan and from the fan to the firewall were
> not installed prior to installing the body.....
> Now, with just about everything else done, I am finding it IMPOSSIBLE to get
> the (new) duct from the firewall onto the fan... --What with the sharp bend
> required and the limited space to work in..
> Any helpful hints?
> ><><><><><><><><><><><><><><><><><><><><><
> David W. Jones
> Cumberland, RI 02864
> 401-658-1265
> davidwjones@cox.net
>
> *
|