Hi Ryan,
You can weld stainless with regular MIG wire, but it will rust over time. I
have seen stainless MIG wire in the 4" spools. You could ask your welding
shop if you can get by with the CO2/AR mix for such a small job. If you have
a torch, you need SS flux. I could send you some, but a white powdery
substance in the mail is not a good thing these days.
Best,
Greg
> -----Original Message-----
>
> I just broke a weld on my (new) stainless steel exhaust. It is
> the little 3"
> piece which connects the two out pipes about 6" in front of the end tips.
>
> Can I use a MIG welder? Is the wire stainless steel?
>
> Is this a pain in the butt or what?
>
> Ryan
> BJ7
|