healeys
[Top] [All Lists]

Re: splash panel detail

To: "linwood rose" <linwoodrose@mac.com>
Subject: Re: splash panel detail
From: "John Rowe" <jarowe@westnet.com.au>
Date: Sat, 22 May 2004 12:32:17 +0800
Hi Lin

When I restored my BT7 a few years ago I found that the fasteners were pan
head #10 x 32 1/2" long with a spring washer and nut. These fitted the holes
exactly.
All other cars I looked at were the same and not self tapping as Rich
suggests.

They are not too hard to install. I don't think I would like to rely on self
tappers in that location as the panel creates a great moment load acting on
those fasteners.


Hopes this helps

Regards

John Rowe
1959 3000 BT7
Perth
Western Australia

> List,
> I have checked the parts manual, numerous vendor catalogs etc., and
> have not been able to determine the correct fasteners to be used on the
> left and right splash panels. The photo on page 70 of the
> Anderson-Moment book shows two of the four fasteners that appear to be
> #10 or 1/4" pan head screws with the heads on the outside of the panel.
> Can someone tell me what they are including their length. I assume a
> split washer and nut on the other side of the panel, although there
> sure isn't much room there? Correct?
>
> Thanks very much.
>
> Lin Rose
> 1960 BT7 in restoration
> 1959 AN5





<Prev in Thread] Current Thread [Next in Thread>