Not sure if the BJ8 is like the my BN7...if so I just put 2 nuts to lock on
the stud that sticks out of the cup. I then pulled in twist motion on the
nuts with pliers. Worked for me. you can spray some liquid wrench type lube
to loosen before hand.
Good luck.
Scott
Mashed BM7
----- Original Message -----
From: "R. Cobb" <rcobb@earthlink.net>
To: <healeys@autox.team.net>
Sent: Wednesday, May 12, 2004 4:56 PM
Subject: hub grease cup removal
> I'm trying to remove the left front hub/disc assembly on my BJ8, Phase
> 2. The stud on the grease cup is bent at an angle (with respect to the
> interior of the hub cylinder) and the cup itself has been battered and
> torn badly and is no longer a continuous circular housing.
>
> Any thoughts on removal techniques without doing damage to surrounding
> parts?
>
> Thanks.
>
> R. Cobb
|