Just finished mine. Foam on the sides, plain on the top. I cut the vinyl
in three pieces per what I pulled off. The seam was hidden under the
chrome beading. I used Weldwood Contact cement on the metal and the
vinyl where it contacts the metal.. A small amout of cement under the
foam to hold it in place, but none on top. I am pleased with the results
and was surprised at the amount of hold the cement had on the narrow
edge of vinyl for the side pieces. Use a heat gun or hair dryer to warm
the vinyl before wrapping it around the back corners of the side panel.
Dave
67 BJ8
60 BT7
>
> Perhaps another Lister has successfully done this job. Which adhesive?
> And was adhesive used between the foam and vinyl, or just between foam
> and metal? I might re-do mine, if I can be sure of making a better job
> of it next time!
|