RE: valve clearance

[Greg Wilkinson <gregwilkinson@adelphia.net>]

Thanks to all who responded. I have ordered a 1.55:1 roller rocker. The 
calculator says I'll have to mill the block some for the exhaust valve, but I 
think I'm ok for the intake. I'll know more when I do the mock-up. Hopefully 
this weekend, more likely next. I talked to my machinist when I picked up my 
ARP enhanced connecting rods and he echoed Michael's spec of .080" clearance 
for valve to piston. Less clearance was needed for the block.

Best Regards,
Greg