healeys
[Top] [All Lists]

Re: Timing the engine ?

To: <healeys@autox.team.net>
Subject: Re: Timing the engine ?
From: "Neil Trelenberg" <neilberg@telus.net>
Date: Thu, 15 Apr 2004 19:53:43 -0700
Good stuff....Neil


----- Original Message ----- 
From: "J. Scott Morris" <jstmorris@yahoo.com>
To: "Big Sixer" <healey@ledwith.com>; <healeys@autox.team.net>
Sent: Thursday, April 15, 2004 5:49 PM
Subject: Re: Timing the engine ?


> Hello Ryan;  The following is from Jim Werner's excellent web site.  Hope
it helps.
>
****************************************************************************
*******
>   From a BMC technical service bulletin dated September 1, 1964
>   ------------------------------------------------------------------------
--------------------
>   Re: Ignition Timing for Austin Healey 3000 Mark I, II and III.
>
>   We have received many requests asking for the actual crankshaft pulley
measurements
>   necessary for adjusting and checking the ignition timing.  We would like
to advise
>   you that the corresponding distance from the T.D.C marking on the
crankshaft pulley
>   is as follows:
>     5 degrees  -  17/64"  (  .265625  or   6.747 mm )
>    10 degrees  -  17/32"  (  .53125   or  13.494 mm )
>    12 degrees  -  21/32"  (  .65625   or  16.669 mm )
>    15 degrees  -  51/64"  (  .796875  or  20.241 mm )
>
>    Source:  http://hometown.aol.com/bgahc/myhomepage/auction.html
>
> --Scott Morris
>
>  --- Big Sixer <healey@ledwith.com> wrote: <<  My Bentley book says set
the timing for my BJ7 at
> 15 degrees BTDC. Which is great, but my vibration damper only has a little
notch in it. I
> estimated the diameter of the damper and using a protractor, estimated
that 15 degrees is about an
> inch on the edge of the damper, which I marked with a bit of white paint.
Is that about right for
> 15 degrees? How have others determined what is the right amount.  When I
moved it to about 1" and
> 1/4 " it ran faster and a bit smoother, but I got some backfiring and a
rumble that sounded like
> after burners. Also, the engine ran on after shutting it down. What's that
all about? What's the
> story with timing? If it is too retarded, what are the symptoms? What are
the symptoms for being
> too advanced? I've been working on cars for 25 years and still forget this
stuff. I guess that's
> because the car hasn't been running for 8 years.  Ryan BJ7 >>
>
> =====
> J. Scott Morris - Keep Smiling, Murphy Lives
>
> ______________________________________________________________________





<Prev in Thread] Current Thread [Next in Thread>