Question: should I actually put the cube on its side, or would it be more
accurate to rest the base against a square block during calibration?
I guess what I'm asking is does the calibration routine account for the fact
that the sides of the cube are not square to the base. Unless otherwise
known, I would calibrate the cube on a known level surface, and use a 90
degree square block against the base for all the side, front, and back
positions.
Best regards,
John Moody
/// Archives at http://www.team.net/archive
/// Check http://www.team.net/mailman/listinfo for other lists of interest.
|