I'm trying to read between the lines here, and when you say
that you "always" get a blank window and a "floating point"
message, I begin to suspect that you have an incorrect
calibration string.
So I'd like to start there, then proceed through your
autostart settings, and then show you how to use the Cut
function to trim your run, as Todd suggested.
Because there are several steps to this, it would be best if
you could call me at 800-775-9511, with your G-Cube and
recording computer there with you, so we can step through
everything together.
THANKS!
--Byron
bob1 wrote:
>
> My auto-stop may be ajusted wrong, I've gotten a couple *.gcd files with time
> over 140 seconds, even though the run was 40 to 60 seconds.
>
> Is there a way to chop off or truncate the *.gcd file ? If I estimate half of
> the data is gabage, and use an editor to chop off the last half it doesn't
>work
> for me. I always get into a mode where the windows remain blank and I get
>dialog
> error boxes starting with: "Floating point division by zero".
>
> Robert Larson
> Portland,OR
|