>>The signal is conditioned to have no change from new all the way
down to
about 6 volts. Below that, however, the readings will indeed change
as
the battery depletes. So I recommend changing the battery at or
below 6
volts. At some point we may have the hardware tell you when that
happens.<<
Could we not do this with software? At calibration time, could we
not record a steady state reading, and then have a quick app to compare
another reading, later down the road? If the cube was not level, I
wouldn't think it would make a difference, just compare the sum of the axis
to calibration?
Just checking? There must be a easy way to check?
Rick
|