fot
[Top] [All Lists]

Re: [Fot] Swamp cooler

To: fot@autox.team.net
Subject: Re: [Fot] Swamp cooler
From: "don@dcphotos.com" <don@dcphotos.com>
Date: Sat, 20 Jun 2020 13:15:13 -0500
Authentication-results: mfg.siteprotect.com; auth=pass smtp.auth=don@dcphotos.com smtp.mailfrom=<don@dcphotos.com>
Authentication-results: mfg.siteprotect.com; auth=pass smtp.auth=64.26.60.150/31@mfg.outbound zbxkPTKe70TNWdUk1Ol2OGx3IfrIJKywOmJyM1qr8uRnWBrbSAGD9+SLjBN+xwfozLY8FcLP/Zi6 eDd9hK9OfPTK0IXH7mOq2+0hMP5OzHq2y4KhHW5AUZq99/v+OWrp+SY7iSuea4HGqwpJcxjRoLZa 1yDPDJF5M1h5Q82brXYy7v2l7RRRT0faNNeCAjrPaSFl/DrSyYB3cNMpgpzRjOj7QCw/gAYT3VPT U/DMAD+bPPZukuF+jPA51CucGfCwfE7cCW8pKMnZ2EaDA1PmQopv7SCYWfiUeOpOTJY7poOkNWCI N8vTCYSL+VcMHHKZ2Ak22ncNz0gKCrov1GasWV1vj2C+0pcXuAT86WptVNwo/cWcelODQ3NOPga0 ShW3DNq7tSCRf0yFBF2moUWeHNDS4qZDIDBdjx85xQq9VD42UbTRudBo31/E3ahF5MMcDI7KdpjQ KXT77Jj3Sw4o8NldtBThiH5R7gKuJOz6hvTOYnc+46EebbgVl4iunqFoEGZzSy+km6VHO6XhXqN3 g0DWG4Tioc84Kpmg5+UpQ2PZprb+nvdWlgS6K9aAlnrXFI3hveFdl8ZztrizlHMncbfC/GUF5F7l H1qjmTOSI4qigDE3xwFiYO0aqOfDVHCLfBtewbOyfDbmyKAkv8F1Tl/4kuCTiUg0aG0PDE27xYC/ F5oNYg1yh1UcgPifqs9Z1959MOfpvKEZg3ZNicViHLzIXRzLkkEE4mVK/YyYYCK2tZM8Dmea0Y6q Z3ER+HnB/zJIHX0r2AxCRH4NuQVwbpv79NqJ6T7Vn6RUCxVPdC/dT6fsWwuActgzcDoFd+96Xw4Q UNtTnfqp5KzbTqNTYni3LizhLvd0m8wH1VE60wTXy2sZdEmtgzxNQVHFWNJyrlrSB7QjjMpQTeg1 FsdCLj5jm+lJmfQyyOMsiN88E1TvIiz8JSz4LWoRj+/mw3fPa219MNac4GmXCxdn071yXlRek1ed 7R3vA53B0OcJuUIwyvWIwKQFl0k38LAE7emxqEYuqIX8nq+xUeUc5++uOHkUMDtoE3I=
Delivered-to: mharc@autox.team.net
Delivered-to: fot@autox.team.net
References: <mailman.1.1592589602.29267.fot@autox.team.net>
Good Idea!
Don


> 
> -------- Forwarded Message --------
> Subject:      Swamp Cooler
> Date:         Fri, 19 Jun 2020 10:19:07 -0600
> From:         Bud Rolofson <levilevi@comcast.net>
> To:   
> 
> 
> 
> Listerati,
> 
> I?ve had some inquires about the swamp cooler on my TR6 I mentioned in 
> another post so here?s the details.
> 
> This only works if you have a scuttle vent that has a pop open lid not 
> the scuttle vent with a plastic grill. 69 through some 72 TR6s had the 
> pop open lid.
> 
> I ran plastic "fish tank" tubing off the windshield wiper fluid 
> reservoir (use distilled water) drilled a small hole in the side of the 
> plenum and connected it to a tiny copper tube (from the hobby store) 
> with a dozen tiny holes drilled into it, cap it on the end with a 
> silicone cap. That tube is wrapped with some porous material and held to 
> the tube by using some magnetic clips from Harbor Freight. The magnets 
> hold the assembly to the bottom of the scuttle lid. Tuck the material 
> down the plenum so air flows through and not around it. I press the 
> washer switch for about 6-8 seconds and before long cool air comes out 
> any or all the round vents or out over the tran tunnel or where ever you 
> set your controls for air flow. It only works when moving of course but 
> today I had cool air coming out nicely on my feet and the upper round 
> vents on my body. With the tonneau cover on and covering the passenger 
> seat the cool air was all directed on me. It was 92 today and I drove 
> around for a couple hours and the reservoir still was 1/3 full.
> 
> You lose having washer fluid for the windshield but I never used mine 
> that I can remember. I'd rather have cool air.
> Plus everything is reversible to stock except for the small hole to the 
> plenum. But I'm never going back. The lid still works as it should and 
> nothing is visible when it's shut.
> 
> 
> Bud Rolofson
> 
> Extreme Parts Racing (more than just a haircut)
> 
> 71TR6 CC57365 (Good 6)
> 71 Spitfire MK IV Race Car #3
> 69 Spitfire MK III (back up FE engine/dinghy car)
> 93 Minnie Winnie Race Support Vehicle 77 Z-50A Hardly Davidson Honda 
> Mini-Trail Bike (Triumph Pit Bike)
> 
> 

_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot



<Prev in Thread] Current Thread [Next in Thread>