You might want to look up Porterfield. I?ve used their R4-1 compound on two
cars (both on the disc pads and the drum shoes) and have been happy with it. I
called them after I received the pads to ask their recommendation for bedding
in the pads and the first person I spoke to laid it out clearly and in detail.
Duncan
(Texas)
> On Jul 10, 2018, at 3:21 PM, DAVE HOGYE via Fot <fot at autox.team.net> wrote:
>
> Hello Friends,
>
> I have been finding out quite a bit about the unusual and developing front
> brake pad, rotor and caliper issues that I have discovered on my TR3.
>
>
> What I found was that the Carbotech CT-57 pads were causing the problem.
>
>
> The supporting or backing plates of the pads had been ground down at
> Carbotech, far under the normal plate width that I measured in 4 other
> production pads that I have on hand. Besides that, they were not ground down
> squarely.
>
>
> This allowed the piston to take tremendous side load under braking causing
> the uneven and diagonal wear pattern in the pads. This also caused the rotor
> to contact the caliper as the pads took on heavy uneven wear.
>
>
> The slot in the TR6 caliper is 3.095" and the four non-Carbotech pads sets
> have a plate width of no less than 3.082". The Carbotech plates have an out
> of square measurement of 3.030-3.050". That's as much as .065" clearance in
> the caliper slot.
>
> The plates have too much clearance. I found that a maximum of .010" backing
> plate to caliper slot clearance is more normal. One set of pads have only
> .005" clearance.
>
>
> Furthermore, the corners of the Carbotech plates and pads were ground down
> far enough that the lower end of the pads hardly made contact with the
> caliper slot allowing more stress on the caliper piston.
>
>
>
> I have been going back and forth with Carbotech on this matter and I will be
> sending back the badly worn set along with a brand set that have the same
> production issues. I bought the two sets at the same time last August.
>
>
>
> What I found is that any backing plates that show evidence of sanding or
> grinding marks should be measured for proper clearance, but that really,
> there should be no sanding or grinding marks...ever.
>
>
>
> All of the other pads I have show no evidence of sanding or grinding marks.
> The previously shaped friction pads are cleanly attached to the backing
> plates and the backing plate is revealed around the friction material. Only
> the backing plate makes contact with the caliper slot.
>
>
>
> It looks like I have to find another race pad supplier.
>
>
>
> Thoughts?
>
>
>
> Dave H.
>
> 831-234-4928
>
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/duncan.charlton54 at gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180710/5b3a48af/attachment.html>
|