IMHO
Having Re & Re?d GT6 powertrain numerous times I?d say just pull it right out.
To lift the engine a few inches to try and work on the pan you?ll have to have
done 90% of the initial work required to just pull it right out anyway. It
will be very awkward to properly clean the mating surfaces without lifting the
unit out and up where you can easily see and get at things. You can also
better inspect the rest of the bottom end etc. And deal with anything that is
suspect. Make sure it?s real clean and you use the best gasket material
available and it shouldn?t leak. Like Scott said check that front block.
I?m sure my engine is milder though, not much better than stock, balanced with
a mild compression boost but I regularly rev it beyond 6000 RPM. I have no
blow by issues as yet.
Best of luck.
Vince
Hello again, Brian. To add to my response to you earlier, Scott is right about
the bellhousing clearance. I have to check my notes, but I believe that when I
lifted the engine, the tranny was out of the car, so I would not have had the
clearance problem. Perhaps if you did not want to get that far into the
project, you could drop the pan enough to cut the gasket out and put a new one
in and use some silicone gasket cement or similar to seal where you cut the new
gasket. Not the best solution, but with that and venting as Scott mentions, it
may be an easy fix to take care of the problem.
-----Original Message-----
Sent: Sun, Jan 21, 2018 12:09 pm
Subject: Re: [Fot] GT6'rs
I?ve never done it. Certainly not without lifting the engine somewhat, and by
the time you undo the water hoses, engine mounts, etc, you are halfway to
pulling it. If you try, you might want to look at how much of a gap there is
between the top of the bellhousing and the firewall, as this could inhibit the
lift.
Venting - I ended up with a 1? and a 1/2? hose on the valve cover and this
cured most of the blow-by issues at the rear seal, etc. The 1/2? hose was not
enough, so now there are two. Also tried a vent off the fuel pump mounting
before the valve cover vents, but the pump cam slung so much oil in this
direction that it didn?t work.
If you are getting oil leaks at the front, that fun sealing block may be the
issue.
OK GT6 guys...
Question... is it possible to pull the pan and change my gasket without pulling
the engine? Looks pretty tight and I expect the oil pump pick up snorkel will
be the problem.
Is a partial lift possible to do this?
It looks like it's pushing oil out of the pan, it's definitely not the timing
chain cover (that's what I thought last year and changed that).
2nd question, if it's pushing oil out the front of the pan (or anywhere from
pan I suppose), I'm thinking I need more crankcase vent? and maybe get around
this problem short term that way?
Let me know, making garage work plans/list of things to do, for when winter
breaks early March
Thanks
Brian
26A GT6+, 28 TR6
Brian Schirano
585-305-0349 Cell
_______________________________________________
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
http://www.fot-racing.com
Archive: http://www.team.net/archive
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180122/7d603d4e/attachment.html>
|