It probably has the later type shell bearings and 1 or both have worked loose
in the laygear housing bore and "milled" into the thrust washer (s).
Glen
-----Original Message-----
From: Greg Blake via Fot <fot at autox.team.net>
To: Fot <fot at autox.team.net>
Sent: Sun, Jan 7, 2018 8:56 pm
Subject: [Fot] TR6 transmission rebuild - counter shaft gears
I am rebuilding a TR6 transmission and ran into a strange snag. When I removed
the countershaft the counter shaft gears did not drop to the bottom of the
case. I had to tap on the counter shaft gear set with a brass punch to get them
to move far enough to allow the input shaft and gear to be removed. Now that I
have the main shaft out of the case, I can't get the counter shaft gears out of
the case. I've been able to move them a little bit by tapping on the gears with
a brass punch through the drain hole but I can't get them out. Has anyone run
into this before? Any ideas to get them out?
Thanks.
Greg
Sent from my iPhone
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180108/6b9e8881/attachment.html>
|