More realistically: Typical single cell lipo is 3.7V nominal, 4.3 V fully
charged so four cells in series is nominally 14 to 16. Volts, which makes
electronic ignition systems much happier than the 12.5 volts of lead acid
batteries. A typical little battery for a RC model is 5000mah (or 5AH in more
normal parlance) and it's a little smaller than a pound of butter. While one of
them might actually crank your motor, five or six is a better bet. I had ten
handy that I'm no longer using (new drone) so I put them together for peyote.
50AH, 1000Amps of cranking current. If I ever draw that my starter wire will
probably vaporize, but the starter spins briskly. pertronix ignition at 6000
rpm draws five amps. So eight to ten hours of running flat out. That's the
biggest load by far unless you're running an electric water pump.
People's bad experience with total loss has to do mostly with lead acid
batteries. Electronics are generally designed to run at alternator voltage of
14V. With typical voltage drop an LA battery might drop to 11V at full load.
LiPos start with a higher voltage and don't droop as much, so everything works
better.
Sent from my iPad
> On Jun 30, 2017, at 8:00 AM, D V <explore8 at outlook.com> wrote:
>
> Elon? Is that you? Drove one of your cars the other day....nice.
>
> Sent from my iPhone
>
> On Jun 30, 2017, at 5:30 AM, Bill via Fot <fot at autox.team.net> wrote:
>
>> You know, these days I could build a battery that would power any race car
>> for a couple of weeks and weigh fifteen pounds. Why would I bother charging
>> it?? It?s 2017. I made a battery recently that lets me weld aluminum. I can
>> put it in a lunchbox. Alternator, really? Why?
>>
>>
>>> On Jun 29, 2017, at 5:00 PM, Bob Totten via Fot <fot at autox.team.net>
>>> wrote:
>>>
>>> What is the size of the shaft on the Denso ??
>>>
>>> Curious,
>>>
>>> Bob T
>>> stom make? Thanks
>>> >_______________________________________
>>>
>>>
>>>
>>> -----Original Message-----
>>> From: Tony Drews via Fot <fot at autox.team.net>
>>> To: John Styduhar <johnstydo at gmail.com>; Triumph 'Friends of Triumph
>>> <fot at autox.team.net>
>>> Sent: Thu, Jun 29, 2017 3:48 pm
>>> Subject: Re: [Fot] Oversize alternator pulley source
>>>
>>> I'm not sure of the shaft diameter on the Denso
>>> alternator, but here's a couple of
>>> possibilities. I think I'm running the first one.
>>> https://www.summitracing.com/parts/sum-g3969/overview/
>>> https://www.summitracing.com/parts/pwm-182/overview/
>>> https://www.summitracing.com/parts/mor-64800/overview/
>>>
>>> basically, search for "alternator pulleys" on www.summitracing.com
>>>
>>> Regards, Tony Drews
>>>
>>> At 09:20 AM 6/29/2017, John Styduhar via Fot wrote:
>>> >I'm running a single groove Denso 55A alternator
>>> >(Lester No. 14684) in my TR racer.? Pulley OD
>>> >is 2 11/16". Does anyone know where to buy a
>>> >larger diameter pulley for this unit or will I have to custom make? Thanks
>>> >_______________________________________________
>>> >fot at autox.team.net
>>> >
>>> >http://www.fot-racing.com
>>> >
>>> >Donate: http://www.team.net/donate.html
>>> >Archive: http://www.team.net/archive
>>> >Forums: http://www.team.net/forums
>>> >Unsubscribe/Manage:
>>> >http://autox.team.net/mailman/options/fot/tony at tonydrews.com
>>>
>>>
>>> _______________________________________________
>>> fot at autox.team.net
>>>
>>> http://www.fot-racing.com
>>>
>>> Donate: http://www.team.net/donate.html
>>> Archive: http://www.team.net/archive
>>> Forums: http://www.team.net/forums
>>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/robertten1 at
>>> aol.com
>>>
>>>
>>> _______________________________________________
>>> fot at autox.team.net
>>>
>>> http://www.fot-racing.com
>>>
>>> Donate: http://www.team.net/donate.html
>>> Archive: http://www.team.net/archive
>>> Forums: http://www.team.net/forums
>>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/bill at
>>> ponostyle.com
>>>
>>>
>>
>> _______________________________________________
>> fot at autox.team.net
>>
>> http://www.fot-racing.com
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/explore8 at
>> outlook.com
>>
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170630/49275fa5/attachment.html>
|