[Fot] Mainshaft ball bearing done!

[Bob Kramer <rkramer3@austin.rr.com>]

Thanks for all the advice both public and private. One suggestion had me going 
into my Dremel tool box where I found a suitable ball to cut away the hardest 
surface and I was able to move to a carbide burr to dig a little deeper 
followed by a 3/16th drill bit. I cut a little at a time and made the perfect 
hole to closely match the one on the original main shaft. It all went well. 
Cheers to the list, I knew I'd get the help I needed!

Sent from my iPhone
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive