I'll add my page, but I am not the best at explaining things. - Larry
http://tildentechnologies.com/Cams/Tip_DegreeCam.html
On 6/17/2016 7:08 AM, Duncan Charlton wrote:
> Iâ??m not sure what you mean by â??set the cam.â??
>
> This describes the centerline method of degreeing a cam:
> http://www.hotrod.com/how-to/engine/116-0701-how-to-degree-a-camshaft/
>
> while this other web page describes the valve open/close timing method:
>
> http://www.lunatipower.com/Tech/Cams/HowToDegreeACam.aspx
>
> or -- if these are not replying to your question this video might answer your
> question:
>
> http://tinyurl.com/hsf3dnx
>
> Duncan
>
>
>>> Bill Babcock got this started for me. Just had a new cam
>>> ground.Exhaust is at 112 degrees, intake at 104; lobe center angle is
>>> 108. Do I set the cam when intake is a maximum lift to 104 or 108
>>> After TDC?
>>>
>> _______________________________________________
>> fot@autox.team.net
>>
>> http://www.fot-racing.com
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/fot/duncan.charlton54@gmail.com
>>
>>
> Duncan Charlton
> Elgin, Texas USA
>
>
>
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/cartravel@pobox.com
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/mharc@autox.team.net
|