--===============6052431567708504422==
boundary="=_7eccf849afc375273fd7a5f1a26387ad"
--=_7eccf849afc375273fd7a5f1a26387ad
Content-Transfer-Encoding: quoted-printable
=0A=0A=09Looking for pros and cons of welding the Lucas distributor. Mos=
t=0Aoperation will be over 3000 RPM's. Max advance should be in by then.=
=0AWe will be running max 6000 RPM with WBC hot street cam and 10:1=0Aco=
mpression with Ross forged pistons.=0A=0A=09If welding is acceptable, wh=
ere should we start with the timing. I'm=0Aguessing somewhere between 26=
and 34 degrees.=0A=0A=09Thanks for any advice.=0A=0A=09Dave and Alex=0A=
=0A=09
--=_7eccf849afc375273fd7a5f1a26387ad
Content-Transfer-Encoding: quoted-printable
<html><body><p>Looking for pros and cons of welding the Lucas distributo=
r. Most operation will be over 3000 RPM's. Max advance shoul=
d be in by then. We will be running max 6000 RPM with WBC hot stre=
et cam and 10:1 compression with Ross forged pistons.</p><p>If welding i=
s acceptable, where should we start with the timing. I'm guessing=
somewhere between 26 and 34 degrees.</p><p>Thanks for any advice.</p><p=
>Dave and Alex</p><p> </p></body></html>
--=_7eccf849afc375273fd7a5f1a26387ad--
--===============6052431567708504422==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
--===============6052431567708504422==--
|