FYI - the new spec bearings are slightly larger diameter OD for the
Cup (race) so it's conceivable that the old design hubs could be
re-machined for the new bearings. Last I knew, the newer bearings I
selected when I did the re-design were half the cost or less than the
original bearings but have the same load bearing capacity. It could
be that after re-machining the hub that the seal holding piece would
no longer fit and new ones would need to be made. Probably the outer
edge could be knurled to get them to fit, the difference is only like
0.010" in OD.
Nothing like the prospect of spending a couple of hundred in bearings
to give new impetus to the search! :)
Cheers, Tony Drews
At 02:36 PM 3/25/2015, Randall via Fot wrote:
>I want to thank all who replied (in case I missed thanking anyone personally).
>
>To recap for the group, there is no automotive application for these
>bearings, they are (expensive) industrial bearings. Still
>available (Summit Racing has them listed as well as many others) but
>not cheap.
>
>Richard Good is now selling very similar aluminum alloy hubs, based
>on the same "uncle jack" design, but they have been slightly
>modified to take a more common (and cheaper bearing). His bearings
>won't fit the original Southwick hubs (unless perhaps the hubs
>can be remachined to suit).
>
>The good news is that I found the bag with the original bearings,
>hiding in a crate marked "TR Brake parts".
>
>-- Randall
>
>_______________________________________________
>fot@autox.team.net
>
>http://www.fot-racing.com
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/fot/tony@tonydrews.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|