By the way I bought a Payen Head gasket and it's .018 thinner than the
offshore head gasket you often get in the gasket kits. Apparently the Payen
gaskets are better quality and getting harder to source. I bought two.
Vince
> On Jun 29, 2014, at 4:07 PM, Jason Sukey <jsukey@gmail.com> wrote:
>
> I'm getting ready to mill the head on my GT6 for a bump in compression. I
> currently measure 3.255" thickness, my math shows that I want to end up at
> 3.215" when I'm done. I can't find much info on how far people are safely
> milling the GT6 version of this head, only TR6 info. Does anyone have
> experience on this? Is there enough meat in the casting to remove this
> much material without hitting water?
>
> Thanks,
>
> Jason Sukey
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/vangoughv@hotmail.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|