I have a set from a TR3. Probably the same as TR4.
Bob
---- Brad Eells <bradlnss@yahoo.com> wrote:
> Hello FOT,
>
> Long, long time since my last post but I found something perhaps worth
> sharing...
>
> I was able to acquire an original set of rear axle traction bars/torque rods
> that were removed from a TR4 being parted out in the mid-west via Ebay. The
> bars prevent leaf spring wind up on hard acceleration.
>
> Kas had these made up in the early 60's and he authenticated my set. I was
> able to determine via casting marks the set was made by Traction Masters in
> Burbank CA. The company exists to this day...Amazingly, they make traction
> bars for vintage cars. I am still able to acquire a set of poly bushings from
> them to fit my bar set.
>
> I inquired if they could still make up bar sets for the Triumph TR3/TR4. They
> said they would be happy too, though they no longer had the plan set for our
> cars. They could create sets using my bars and mounts as a pattern. A one off
> set will run around $175. A group buy could potentially lower the set price.
>
> I had considered these traction bars as "unobtainium" having never seen a set
> come up on Ebay until I found the set I now have.
>
> The question for the group is if there is any interest in creating some new
> Traction Master Bars from the original manufacturer?? I am happy to share my
> set for the pattern making as the car is a long way from needing them.
>
> Cheers,
>
>
> Brad Eells
> Meridian ID
> 62 TR4 Racer
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/rdavis4@cfl.rr.com
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|