I would be most interested in what the slave is actually doing when you press
the peddle. At least That will tell you if its 'before' or 'after' that point.
J.O. FGR.
------Original Message------
From: Mike Moore
To: 'FOT'
Subject: [Fot] TR4 clutch, help
Sent: May 9, 2013 7:01 PM
This is for my race car that I am getting ready for Jefferson 500.
I had to put in new clutch master (Wilwood 5/8, same as was in car), and new
slave (stock from Roadster factory.
With car running when I try to engage gear I have to push clutch all the way
to floor, works in last half inch, but then the clutch pedal sticks and
won't come back up.
I have bled a lot and don't see any more air bubbles.
Do I need to adjust rods on either cylinder or is it air.
Thanks
Mike
Michael T. Moore, CPA
2007 West 32nd Street
Erie, PA 16508
Phone: 814-868-4831 ext 103
Fax: 814-864-7383
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
Sent via BlackBerry by AT&T
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|