also on the hunt for a machine shop that can do the long line boring procedure
to allow cam bearings for the GT6...
Bobby
________________________________
From: Kurt Oblinger <koblinger@verizon.net>
To: Friends of Triumph <fot@autox.team.net>
Sent: Thu, December 27, 2012 12:19:19 PM
Subject: [Fot] So Cal Machine Shop Recommendation
Looking for recommendations for machine work for a GT6 engine. Just typical
rebuild work; clean the block, check the crank bore and align bore if needed,
turn the crank, balance, etc, etc. Prefer the So. Bay, Redondo, Torrance area
or
possibly Long Beach.
TIA,
Kurt Oblinger
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/fot/igofaster@att.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/fot/mharc@autox.team.net
|