I hope this message comes across well, the FoT formatting doesn't seem to
carry over from MS Word well. Forgive me of it is indecipherable and/or
incomprehensible...
I'm finally assembling a Kastner Octopus system for my GT6.
I'm assembling an octopus using the aluminum manifold Steve Smith gave me. I'm
plumbing it with Parker Push-Lok hose & fittings, which are rated to 350 psi
and the hose bends easier than braided steel. I'll back the ends up with hose
clamps too.
Opinions of the correctness of this?
A lot of oil plumbing under the hood:
* -10 oil cooler lines
* remote oil filter mounted on firewall
* oil pressure gauge line
* oil temp gauge line
* -10 Accusump feed line & anti-backflow valve
* -10 main oil supply line
Fittings, adapters, tee's, etc...
Big VARA race weekend coming right up at Willow Springs. Kas featured all
Triumph race, enduro, and I hope a good amount of madcap antics & wacky
hijinx.
Ed Dunn
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net
|