When Uncle Jack was making up the brackets for his TR6, I suggested that
there was a market for these as a kit.
Sean Alexander and Jack worked on the design together. Sean worked on the
design for manufacturing in a production mode. They are laser blanked, formed
and powder coated. A hardware kit comes with it and it is shipped in a custom
box.
Tony turned the project over to Sean after Jack died. Sean has made
improvements to the kit with the help of the TR6 guys.
It fits several models of Triumphs. Paul Rego in the east coast is preparing
to fit Miata Seats in a TR8.
It has become a very popular conversion.
Joe Alexander
A. R. E.
645 1st Street
Jesup, Iowa 50648
319.464.4711 (cell)
n197tr4@cs.com
-----Original Message-----
From: Enquiries Road & Track <enquiries@roadandtrack.net.au>
To: fot <fot@autox.team.net>
Sent: Fri, Mar 16, 2012 4:55 am
Subject: [Fot] alternative seats for TR6
has anyone found an alternative seat that will fit into a TR5/250 or TR6
(road use, not race car)?. i've looked at some Toyota MR2 ones, and they
are close, but just a little bit too wide at the front.
thanks, Terry
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/n197tr4@cs.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net
|