[Fot] Fwd: TR3 TR4 REAR ENGINE MOUNTS NEW DESIGN IN THE WORKS

[Joe Alexander <n197tr4@cs.com>]

 Glen,


Yup, we've done that, too, and it works.

Yet, we'd like to take a step further.

Greg Solow interjects some thoughtful observations that may be incorporated
into the design, eventually..

Keep the comments and interest coming....we have about 8 responses in about 4
hours. There must be an interest.

There seems to be an opportunity to relieve some stresses from the
gearbox....stresses that have been known to crack bellhousings. Stresses that
might not be very good for the gearbox internals, either. Time to think
outside the GEARBOX, as it were.



Joe Alexander
A. R. E.
645 1st Street
Jesup, Iowa 50648
319.464.4711  (cell)
n197tr4@cs.com





-----Original Message-----
From: fubog1 <fubog1@aol.com>
To: n197tr4 <n197tr4@cs.com>; malaboge <malaboge@aol.com>; fot
<fot@autox.team.net>
Sent: Fri, Mar 9, 2012 3:04 pm
Subject: Re: [Fot] TR3 TR4 REAR ENGINE MOUNTS NEW DESIGN IN THE WORKS


 A short length of "angle iron" with a half inch hole in it fastened under the
tailshaft boss on each side, with the flat face butted up against the end of
the mount, to take the lateral loads.
This is pretty much SOP, easy to do, and works great.
Glen
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: 
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net