Chris,
I have the machinist that's doing the work check for round and determine how to
size the journals.
I would just like to have a method that I can use to back check the machinst
and/or check clearances
while the motor is in the car.
Jim G
----- Original Message -----
From: "MadMarx" <tr4racing@googlemail.com>
To: "Friends of Triumph" <fot@autox.team.net>
Sent: Thursday, August 11, 2011 9:18:37 AM
Subject: Re: [Fot] Proceedure for checking rod bearing clearances
I never used plastic gage for the bearing clearance.
To measure this I always take dial gauges which in my opinion is more
precise as you can also estimate the out of roundness of the parts.
Cheers
Chris
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von toodamnfunky@comcast.net
Gesendet: Donnerstag, 11. August 2011 00:14
An: fot
Betreff: [Fot] Proceedure for checking rod bearing clearances
FoT
With the rods I have, in order to seperate the caps I have to back out the
bolts
a few turns and tap the bolts with a soft mallet to seperate them.
I use plastigauge to check my main clearances but it seems that tapping
on the rod bolts may tend to affect a plastigauge measurements on the rod
journals. I'd appreciate any feedback on checking rod clearances.
Thanks as always,
jim g
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/tr4racing@googlemail.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/toodamnfunky@comcast.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|