We have had good results with the Payen, which is what I think you mean by
"OEM style, and it is still available from NWBP. At least it was a couple
of weeks ago when I stocked up on them. We're running a bit above 11:1 C.R.
We don't use any gasket dressing, as I recall.
Tim Murphy
1961 TR4 #317
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of n197tr4@cs.com
Sent: Wednesday, April 27, 2011 6:17 PM
To: fot@autox.team.net
Subject: [Fot] headgasket approaches tr3 tr4 a brief summary. fyi
1. OEM style gasket
2. OEM style gasket with copper wire in liner groove
3. Steel shim gasket with copper wire
4. Steel shim gasket w/out any wire.
5. Copper gasket with steel wire in head groove.
6. Cometic gasket
Gasket dressing varies
We have done most all with reasonable success....except Cometic.
Surprised at limited number of responses..... and the variety of solutions.
Perhaps gasket sealing is a non issue or everyone is busy changing head
gaskets.
It appears that OEM style is understandably the most forgiving, but concern
remains that it might not work well with the typically modified head.
Joe A
I suppose we should assume that all surfaces and assemblies are in spec.
I'd like to see a Cometic and try it...we have one on order but will not
receive it in time for this engine assembly.
Anyother comments.....??
=
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/timmurph@fastbytes.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|