FoT
I am preparing a fresh crank ( stock ) for next season and I want to do
everything I can to bullet proof it. I will start with Magnafluxing it, then
shot peen, then cryo treatment, balanceB and finally nitriding.
I have had my issues with # 2 main in the past and I want to improve
( if possible ) the oil flow and or volume as best I can.
I have heard the passage in the crank can be drilled out a bit and also
heard the angle of the passage can be changed to better apply oil to
the bearing rather than scrape oil. This will also give me the opportunity
to try Chris's new rear main seal.
Also, has anyone tried different oil pick up configurations or manufacturers?
Any advice would be appreciated.
Thanks,
Jim G
# 102
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|