Thanks for the update on the outcome. That's really good information.
Tim
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of M&M Hado
Sent: Wednesday, May 05, 2010 9:39 PM
To: fot@autox.team.net
Subject: [Fot] A-Type Overdrive Slipping - Final Outcome
Last week I started a thread on a problem with a slipping overdrive and I
thought some may wonder how it worked out. One of the "long" springs was
installed on the inner, or shorter, land and was coil bound. That's only
one out of the four and that's all it took.
I checked a couple dozen springs that I had and found that it does not
matter what the free length is, whether it is LH or RH wound coils, or even
what the end color is, the only thing that really matters is the length when
fully compressed, or coil bound. All of my springs were either 3" or 2.5 "
when fully compressed. The 3" go on the outside and the 2.5" go on the
inside land. Go by that and you'll always be fine.
Thanks to all who offered suggestions and led me to the simple solution.
Mike
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/timmurph@fastbytes.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|