Greg,
I Just use some very THIN soldering wire wrapped a couple of times around
the thread/under the washer. You can get a roll of this from any goods
electronics/electrical shop for a few dollars. Works good for me.
Cheers...
Kind Regards
Peter Vucinic
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Greg & Alison Blake
Sent: Wednesday, 5 May 2010 9:39 AM
To: fot@autox.team.net
Subject: [Fot] TR3/4 filter head relief valve
I am trying to solve the little seeps I have around the filter head. Has
anyone used an o-ring under a washer to seal the pressure relief valve
adjusting screw lock nut? I thought I would give this a try but the o-rings
available at the local autoparts store seems to be too thick and stand proud
of the chamfer that used to be sealed by a lead wire.
What have you guys used?
Thanks,
Greg
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/pvucinic@netspace.net.au
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|