fot
[Top] [All Lists]

Re: [Fot] Annular clutch slave cylinder

To: chasgee@aol.com
Subject: Re: [Fot] Annular clutch slave cylinder
From: "Joe Boruch" <jaboruch@netzero.net>
Date: Tue, 23 Feb 2010 03:48:23 GMT
I am using the one from Howe racing, with a Tilton clutch.  Since I am using a
T5 tranny with my own bell housing the hydraulic throw-out bearing mounts on
studs on where the original TR tranny nose bolts up.  I had to reduce the
diameter of the T5's nose for the bearing to fit over the nose.  I ran braided
hose to it, one thru a throw-out bearing shaft hole and the other thru a new
hole that I bored in the case.  The top hose has the bleeder.  Joe(B)

---------- Original Message ----------
From: chasgee@aol.com
To: FOT@autox.team.net
Subject: [Fot] Annular clutch slave cylinder
Date: Mon, 22 Feb 2010 20:36:04 -0500

FOT,

Is any one using an annular clutch slave cylinder on their TR4 through TR6
transmission?  If so, which one are you using and how did you mount it?

Thanks,

Chuck Gee
Suggested annual donation $12.96

You are subscribed as jaboruch@netzero.net

http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.



____________________________________________________________
Get Free Email with Video Mail & Video Chat!
http://www.netzero.net/freeemail?refcd=NZTAGOUT1FREM0210
_______________________________________________

Support Team.Net http://www.team.net/donate.html

Suggested annual donation $12.96


http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.

<Prev in Thread] Current Thread [Next in Thread>