> > I have what I believe to be a set of your TR3/4 Nylatron Rocker Arm
> > Spacers (sourced from Moss).
> >
> > Are these to be installed with a side clearance between the spacer and
> the
> > rocker arm? What is the spec?
>
> ---------------------------------------------------------------------------
> -----------------------------------
> Yes...there are supposed to be instructions that ask for .010 min as a
> 'guide' to allow for unknow rates of expansion.
>
> ---------------------------------------------------------------------------
> ----------------------------------
> >
> > What is the best way to shave a few thousands off this material? Flat
> > surface and 600 cloth?
----------------------------------------------------------------------------
------------------------------------
>
> This will work and is suggested in the instructions. Other producers
> simply
> make them way too short. I wanted to position the tip to the stem so it
> was
> consistent.
> ---------------------------------------------------------------------------
> ---------------------------------------
> > I am using a set of the special rocker arm pedestals that support the
> > ends of the rocker shaft sourced from British Frame and Engine. I have
> not
> > put the calipers to the pedestals yet, maybe they are slightly thicker
> than
> > stock?
>
> ---------------------------------------------------------------------------
> ----------------------------
> Uncle Jack encountered this and removed a little extra material. He was
> very pleased with the outcome and included the spacers on all of his
> engines.
>
> Longevity: Mike/Steve Belfer have used a Delrin Set for over two decades
> and they are still on one of the original engines. And Delrin has a
> slightly
> lower heat working range.
>
> Joe Alexander
>
> For further entertainment look at photobucket.com/ambro there's
> also some stuff in process of development, but not in production yet.
>
>
</HTML>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|