On 12/22/2009 3:17 PM, steve wrote:
> Oops, sorry about the typos. The heater pipe hasn't screwed anything as far
>as I know!!!
>
> I need a plug to block off the heater pipe hole atop the head. :)
>
> -----Original Message-----
>> From: steve<colordog.1@earthlink.net>
>> Sent: Dec 22, 2009 11:40 AM
>> To: FOT<fot@autox.team.net>
>> Subject: [Fot] Engine Plug Sizes, oil press pickup
>>
>> FOT,
>>
>> What sizes are the following plugs for the TR3/4 engine:
>>
>> 1, top of Cyl Head where heater pipe screwed it.
1/2" NPT
>> 2, Manifold side of engine block to drain H2o.
1/2" fine thread
--
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|