fot
[Top] [All Lists]

Re: [Fot] wiper arm ID

To: "Tony and Annie Garmey" <horizonracing@msn.com>,
Subject: Re: [Fot] wiper arm ID
From: "Charly Mitchel" <charly@mitchelplumbing.com>
Date: Wed, 11 Nov 2009 14:48:01 -0800
Hey Tony,  TR250 & TR4A are the same and TR6 uses about 3 different kind. 
Some are black on later cars and some are LHD or RHD.  The TR6 is a little 
shorter than the 13.25 inches at about 12 inches.  One side of the TR6 is 
also bent to be parallel to the lower windshield frame about 45 0.  The 
other side is slightly bent but only a couple of degrees.   I have a bunch 
of arms laying around and I can look through them.  Is this arm straight or 
is it crooked as if in a LHD or RHD mount?
Charly Mitchel
TR6 #44
----- Original Message ----- 
From: "Tony and Annie Garmey" <horizonracing@msn.com>
To: <fot@autox.team.net>
Sent: Tuesday, November 10, 2009 2:16 PM
Subject: [Fot] wiper arm ID


> FOT'ers,
>
> I trying to ID a wiper arm of a Ferrari 275 GTB. YES, believe it! they 
> used
> Lucas parts  on these things. Must be pay back ! :)
>
>
>
> O/All length is at 13 1/4
>
> width @ pivot pin is 3/4
>
> The outside Diameter of the piece that goes over the "wheel" is also 
> approx.
> 3/4
>
>
>
> These arms might be off a TR 6 ? or 250
>
>
>
> Thank you to all
>
>
>
> Tony Garmey
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as charly@mitchelplumbing.com
>
> http://www.fot-racing.com
>
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> Brought to you by Team.Net consulting - Unix software specialist.
>
>
> You are subscribed as charly@mitchelplumbing.com 
_______________________________________________

Support Team.Net http://www.team.net/donate.html


http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.



<Prev in Thread] Current Thread [Next in Thread>