This a poor boy approach that some of you will scoff at, but I've done
it and it works. Have you ever heard of a "strawberry fit"? Peck
around on the surface with a punch, then use loctite sleeve retainer as
Randall suggested. This is not a good approach if you're planing to
take the bearing off many more times. In that case, you might be able
to turn the surface down to the size of a different bearing, or you
could turn it down and sleeve it back to size.
Larry
Randall wrote:
>> What can be done to get these
>> bearing surfaces built back up to spec?
>>
>
> There are several Loctite products designed for this purpose. I've had good
> luck with RC609, though not on a diff. RC603 might be a better choice,
> though, as it's supposedly stronger and tolerates contamination better.
> http://207.250.200.229:8080/1/doc?id=26269
> http://tinyurl.com/n9276o
>
> Randall
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> You are subscribed as cartravel@pobox.com
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|