I second that. The pins are pushed into holes in the tubing very close
to the edge of the tube and it can easily break out. I've had it
happen to two rear ends. The banjo welds nicely as do the tubes. I run
short beads about an inch long, spaced about an inch apart. Permanent
fix.
On Aug 19, 2009, at 7:11 PM, Joe Boruch wrote:
> Teriann, weld the axle tubes to the diff housing. The pins work
> themselves
> loose, so also weld the pins in. The housing is basically cast
> steel and will
> weld fine with a mig welder. Joe(B)
>
> ---------- Original Message ----------
> From: "TeriAnn J. Wakeman" tjwakeman@gmail.com
>
> #1 I have gear lube weeping between the diff housing and the axle
> tube.
> Assuming that doesn't mean an axle tube is about to fall off (I hope
> not) what is the best way to seal this weep? Braze the junction all
> the
> way around? or ??
>
> Teriann
> ____________________________________________________________
> Compete with the big boys. Click here to find products to benefit
> your
> business.
> http://thirdpartyoffers.netzero.net/TGL2231/fc/BLSrjnxUki9SBXpRqqlFzfWFNMXgT2
> x4zMgHdxHwGKuBC4h19L9lNFAfx2A/
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> You are subscribed as billb@bnj.com
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|