You can usually get felt strips from your local bearing supplier as it is
used as a seal on some design plumber block bearings
Cheers...
Peter V
TR4
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Tim Murphy
Sent: Saturday, 31 January 2009 8:49 AM
To: tr3a58@verizon.net; fot@autox.team.net
Subject: Re: [Fot] TR3/4 engine builders
I ordered some from Moss about a year ago and they were the right size,
rectangular about 1/4 inch by 1/2 inch.
Tim Murphy
1961 TR4 #317
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of tr3a58@verizon.net
Sent: Friday, January 30, 2009 3:43 PM
To: fot@autox.team.net
Subject: [Fot] TR3/4 engine builders
For the past several years I have been using Payen gaskets for my
engines. I received a gasket set this week and the felts for packing
the rear main cap is way too small. Any body else seen this and where
can one get proper sized felts?
Dean T.
Felt less in Virginia........
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
__________ NOD32 3811 (20090129) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|