Steve,
What clearance do you have now? What is the recommended STD clearance for
the Helpolite Piston? 3 to 4 thou?
If you use this information to determine the fit, along with what Kas has
suggested regarding turning the sleeves, that's a good start. At least you
will be placing the piston thrust faces on a part of the liner that should
be pretty good for size/fit. As long as the liners aren't scored heavily.
Cheers...
Kind Regards
Peter Vucinic
TR-4 WORKS
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Steven Belfer
Sent: Saturday, 1 November 2008 3:59 AM
To: FOT
Subject: [Fot] TR3 / 4 Piston to Wall clearance
I have a well used race motor in the machine shop. It's got Hepolite
Powermax cast pistons and 87mm sleves that have seen many races.
The liners may need a bit more than a light honing to freshen them
up. What would you accept as the max allowable P to W clearance?
I don't really want to buy new liners if I don't have to.
~Steve
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
__________ NOD32 3571 (20081030) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|