Scott, My mailer-Demon is rejecting your address. Contact me direct, Steve
In a message dated 10/28/2008 5:42:13 P.M. Pacific Daylight Time,
s.janzen@comcast.net writes:
For my GT6 vintage racer/hillclimb car, I am looking for recommendations for
a
cam grind that will give me more torque/horsepower at a lower rpm than the
Crane grind F-254/325-8 in the engine now. It's 300 degree duration, intake
opens at 47 degrees BTDC w .016 lift, closes 73 ABDC. It is pure road race
and really starts pulling at 5,000 rpm up to 7,000. Would like to move this
down to low 4,000 range, given that I run some hill climbs and try not to go
over 6,500 rpm most of the time.
Engine is 11:1, roller rockers, ported head, 6-2-1 headers, three weber 40
DCOE.
Suggestions?
**************Play online games for FREE at Games.com! All of your favorites,
no registration required and great graphics b check it out!
(http://pr.atwola.com/promoclk/100000075x1211202682x1200689022/aol?redir=
http://www.games.com?ncid=emlcntusgame00000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|