I use one of Justin's gaskets on my TR4 but don't have it glued to the
valve cover as shown on this guy's website. Since the gasket expands
significantly when hot, is it feasible to glue it to the cover for a
race car since we tend to remove the valve cover between sessions? Now,
it goes into a fridge or ice chest until it shrinks back to normal size.
Don
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of igofaster@charter.net
Sent: Sunday, July 06, 2008 7:30 PM
To: fot@autox.team.net
Cc: fot-request@autox.team.net
Subject: [Fot] Justins TR6 gaskets
Man... I thought I was annal retentive... this guy takes the cake...
funny all that stuff on a TR6 engine with THREE STROMBERGS??? Poor guy,
no roller rockers or spacers for the rocker arms even... I think I've
seen the three carb setup on eBay before...
I have one of the gaskets on the racer GT6 and no problems... I like it
so much, I'm going to get another for Barbra's TR6...
All the best kids!
Pray for world peace,
Bobby Whitehead
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|