fot
[Top] [All Lists]

Re: [Fot] CRANKCASE EVACUATION SYSTEM

To: <N197TR4@cs.com>, <pvucinic@netspace.net.au>,
Subject: Re: [Fot] CRANKCASE EVACUATION SYSTEM
From: "Bill Babcock" <BillB@bnj.com>
Date: Sun, 30 Dec 2007 20:45:56 -0800
I might have to give it a try. Of course that means Peyote is going to rust.


-----Original Message-----
From: N197TR4@cs.com [mailto:N197TR4@cs.com]
Sent: Sun 12/30/2007 8:02 PM
To: pvucinic@netspace.net.au; Bill Babcock; wgrosenbach@juno.com;
william.tobin3@verizon.net
Cc: FOT@autox.team.net
Subject: CRANKCASE EVACUATION SYSTEM

GM has a typical check valve for $10-15 if you make your own.

This system will:  "...provide better piston ring seal, less intake charge
contamination, and reduced oil leaks caused by high crankcase pressure."

This is from a circle track catalog. A little marketing hype built in here, I
sense.

Moroso, Mr. Gasket, and Renegade provide these kits to the circle track guys.
There are pieces uneeded for Triumphs and no hi temp poly tubing, which may
be the most expensive item.

I have no understanding of why they are not permitted in the SCCA GCRs.
Likely for good reason in certain applications...V-8s?

But for TR3/TR4 engines, it seems like an appropriate modification.

I was putting a lot of oil into the frame rails and then would dump it ON the
exhaust pipe at Turn Five at Road America. Not a very pretty cloud of oil
smoke and of some concern to the corner workers.

After going home, I would let the TR4 drip for a couple of weeks, then wipe
it down.

This system changed all of that.

Joe A



> Bill,
>
> To avoid ANY back pressures you should fit a one way / check valve at the
> exhaust venture. These type of check valves are available on some emission
> vehicles. Problem solved. That what I have on my TR4.
>
> Peter V
> TR-4
>

   </HTML>
_______________________________________________
http://www.team.net/donate.html

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>