I believe your asking for the compression height, i.e. the distance from
the wrist pin center to the top of the piston. Someone please correct
me if I'm wrong, but I believe you need a 2.000 in compression height to
put the top of the piston level with the deck.
Greg & Alison Blake wrote:
> Can anyone tell me the crown height for a stock TR3 piston? If I order
> the stock height + .005, will I have enough extra to mill off to get a
> zero deck height? As far as I know the block has not been decked in the
> past.
>
> Thanks,
>
> Greg
> _______________________________________________
> http://www.team.net/donate.html
>
> cartravel@pobox.com
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|