I like about 1 inch down in the bore to 1.75.
this is where it counts.
OHC motors hard to loosen, but easy to see.
full degree marks on the damper a big help
art d
----- Original Message -----
From: "Jack W. Drews" <vinttr4@geneseo.net>
To: <fot@autox.team.net>
Sent: Wednesday, September 26, 2007 12:29 PM
Subject: [Fot] leakdown tester, follow-on question
> The "normal" way to do this test is to set the piston at top dead
> center. But if you take the rocker assembly loose, then all the
> valves are closed. Doing it this way, cam position is eliminated as a
> factor. Then, has anybody checked leakdown in a TR wet sleeve engine
> at, say, top, half stroke, and bottom of stroke?
>
> uncle jack
>
>
>
> ------------------------------------------------
> No Virus Found In This Message
> Scanned at barracuda.geneseo.net
> _______________________________________________
> http://www.team.net/donate.html
>
> riverside@cedar-rapids.net
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
>
> --
> No virus found in this incoming message.
> Version: 7.5.488 / Virus Database: 269.13.31/1031 - Release Date:
> 9/26/2007 12:12 PM
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|