Mount the heat shield inboard of the soft mount - so you've got
intake manifold, gasket, heat shield, soft mount, carburetor.
- Tony
At 09:30 PM 7/9/2007, Joe Boruch wrote:
>Yes, remove the stock fiber spacer. I have the weber soft mounts isolating my
>SU's too, but am not using a heat shield, so I can't help you there. I
>installed longer studs to make this work. I think I had to elongate the holes
>on the O-ring plates. It is ok that the plate only catches 2 studs, since
>they are diagonally opposite You are not tightining the nuts down tight, so
>that isssue is a non-issue Use nyloc nuts to keep them from vibrating loose.
>Joe(B)
>
>-- "Gary" <vintage.racer@comcast.net> wrote:
>Hello:
>
>I have acquired a set of Weber Carb "soft mounts", ie, thin metal plate with
>rubber O rings on each side, to help reduce the vibration getting to the SU
>carbs on my TR4 racer. Questions: do these replace the normal 1/4" thick,
>hard material, carb insulators? Since the soft mount only has two bolt
>holes,
>what should be used as a spacer for the other two carb bolts? I have one of
>Joe Alexander's heat shields for the carbs, should this go directly against
>the intake manifold with the soft mount on top or vica versa? Thanks.
>
>Gary
>1962 Flying Brick
>1969 TR6
>jaboruch@netzero.net
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
>
>_____________________________________________________________
>Click here for free information on nursing degrees, up to $150/hour
>http://track.netzero.net/s/lc?u=http://tagline.untd.us/fc/Ioyw6ijmZj0RCkaghhR
>oQD9Od6wHGzj1hNEFLQnITws740pCR83AuE/
>_______________________________________________
>http://www.team.net/donate.html
>
>tony@tonydrews.com
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|