Stahl is the only way to go!
Anything else is a waste of money. The stock Mk2 is not bad for an 1147, but
you'll never regret the Stahl once you put it on. You will need to cut out a
portion of the belhousing and the rear engine plate, but it's worth it. You
will notice the difference.
Russ Moore
----- Original Message -----
From: "Norlin Engineering" <norlinengineering@comcast.net>
To: <fot@autox.team.net>
Sent: Tuesday, June 26, 2007 1:55 PM
Subject: [Fot] Spitfire Headers
> Does anyone know of a ready source for Spitfire headers that will stay
> tucked up in the frame? This is for a 1300 and the engine builder says I
> should stick with a tri wye design for the prep level of the motor he's
> building. The headers available from the sources I've found so far are
> apparently for street cars since they hang 1 1/2 to 2 inches below the
> frame.
>
> Thanks
>
> Jim Norlin
> _______________________________________________
> http://www.team.net/donate.html
>
> rem9@frontiernet.net
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|