I must have had HTML in my last response. Let's try this again:
Cutoff switch is at http://www.racerpartswholesale.com/rebco5.htm
. I've got the REB-1601500 which has a couple of posts for the
alternator too. I MUCH prefer that switch over the models below it
on that web page. Much simpler wiring than the ones where the
ignition goes through terminals on the switch.
- Tony
At 09:50 PM 2/14/2007, Robert D. MacKenzie wrote:
>As you all may remember, I am in the process of
>building/restoring/re-building a 1962 Spitfire Mk1 race car. The
>project is going very well. I have reassembled the rear suspension and
>overhauled the brakes (although the master has since developed a nasty
>leak - but that's another project. Currently the car is at Cutting Edge
>Racing in San Antonio getting a new roll cage with side bars as well as
>new Kerkey vintage style seats.
>
>One issue I have been struggling with is that of the instrumentation and
>wiring.
>
>I want to re-create the look and feel of the original car with a
>tachometer and gauge set in the center panel of the dashboard. I plan
>to keep it very simple and hoped to just have two large gauges, the
>tachometer and a combo oil pressure/oil temp/water temp gauge
>
>I have looked at several catalogs and web-sites and can't seem to find
>just what I am looking for. Auto Meter has the closest to what I had in
>mind but I am looking for some direction from the group on other options
>and where to source sending units for the various temps and pressures.
>
>Also, I want to install the external electrical shut-off switch as
>required by most race clubs. Any sources on that particular item would
>also be appreciated.
>
>
>
>Robert MacKenzie
>62 Spitfire Mk1 (Race)
>79 Spitfire 1500 (Street)
>San Antonio, TX
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|